LNVR

How to configure exacqVision Server  Procedure Steps Follow these steps carefully to configure the exacqVision Server  with OnGuard: 1) Install the Accessory Add-On for exacqVision Support  on the OnGuard workstation. (located in the Partne...

Question Why can't I set the recorded frame rate higher than X frames per second? Substitute X for whatever rate of frames per second is in use. Answer OnGuard automatically limits the recorded frame rate to be no higher than the live f...

Question What is the recommended free space setting for an LNVR storage drive? Answer The recommended free space for an LNVR storage drive is 10%. This amount will ensure that large read, write, and delete actions complete reliably and corr...

Symptom When attempting to add a camera in the Digital Video folder in System Administration, the specific IP camera type is not included in the drop-down. Resolution In System Administration: 1) Check the Capabilities Chart for the instal...

Question What is the Storage Calculator and how can I obtain this tool? Answer The VideoManager Storage Calculator is a utility that enables you to design LDVR and LNVR camera configurations to provide an estimated network utilization and r...

Question How do I send my LDVR or LNVR in for repair? Answer 1) Call Lenel Technical Support for an RMA number. If the LDVR or LNVR is out of warranty and the unit is not End-Of-Life, there may be an evaluation fee for any repairs. 2) Pack...

How to determine what protocol an LVNR is using to send video to client workstations Procedure Steps The LNRNI.exe utility can be used to define how a client requests that LNVRs attempt to send video (protocols, port ranges, etc).  The LNVR co...

How to Uninstall an Lenel NVR Server from a Windows System Procedure Steps Note: This article is written for all versions of Lenel NVR releases. It is aimed at documenting all of the relevant paths where Lenel NVR components could be fou...

How to set the CPU limit for Alarm Monitoring or VideoViewer on client computers displaying video Procedure Steps 1) Exit the Alarm Monitoring or VideoViewer application. 2) Open the ACS.INI file in a text editor and add the following lines...

How to configure network storage for the LNVR Procedure Steps LNVR network storage must be formatted in a specific way. Mapped drives appear in the Available Locations list, but will not function properly and should not be used. The full UNC pa...