Readers / Biometrics

Symptom Your HID iCLASS OSDP reader may not function properly when used in OSDP mode. The reader will function properly when wired as a non-OSDP (Wiegand) reader. Resolution 1) Ensure the reader is a supported HID iCLASS OSDP reader. For ver...

Symptom After upgrading the firmware on an LNL-1320 to revision 1.36 and higher, you may find a reader connected to the LNL-1320 appears online in the System Status Tree in Alarm Monitoring, but with a status of "Device Type Mismatch". In this ...

How to install and configure the PIV OmniKey reader Procedure Steps Install the OmniKey drivers: 1) Run the driver installation package, located on the OnGuard Supplemental DVD at one of the following locations, depending on the OmniKey reader ...

How to wire a V-Pass FX to an LNL-2220 or LNL-1300/1320 Series 2 reader port Procedure Steps To correctly install a V-Pass FX using the LNL-2220 or Series 2 LNL-1300/1320 (instead of an LNL-500B), wire the device as follows. 1) The V-Pass FX ...

How to configure the MV1610 V-Pass FX as a USB enrollment reader Procedure Steps 1) Verify and obtain the appropriate firmware. - Refer to the Third Party Hardware compatibility chart on the Partner Center for the correct version of OnGuard. -...