How to configure an NGP-1208
Procedure Steps
The NGP-1208 boards are output expanders that are used to add additional output points to the system in groups of eight. The NGP controller can be licensed to support a maximum of sixteen output relay control modules.
The NGP-1208 must be attached to the NGP-1100 input control module using the VBUS connection. Up to four NGP-1208's can be connected to any one NGP-1100. Consult the NGP Hardware Installation Guide for Hardware instructions.
To configure NGP-1208(s) within OnGuard:
1. In System Administration, navigate to Access Control > Alarm Panels.
2. Select the Alarm Panels tab
3. Select the NGP-1100 panel to which the NGP-1208(s) will be connected and click Modify.
4. Change the Number of Outputs to 8*(number of NGP-1208(s)).
5. Click OK.
For example, if there will be two NGP-1208 boards connected to an NGP-1100 named "Labs":
1. In System Administration, navigate to Access Control > Alarm Panels.
2. Select the Alarm Panels tab
3. Select "Labs" and click Modify
4. Change the Number of Outputs to 16.
5. Click OK
1. In System Administration, navigate to Access Control > Alarm Panels.
2. Select the Alarm Panels tab
3. Select "Labs" and click Modify
4. Change the Number of Outputs to 16.
5. Click OK
Note: The Number of Inputs will be 16 for each NGP-1100.
Applies To
NGP hardware
Your Privacy Choices