Symptom
LNL-8000 Port 1 is not communicating with OnGuard.
Resolution
Controllers* | Downstream Boards Series* | LNL-8000 (Rev ? – 1.01) | LNL-8000 (Rev C¹ – 2.01.0) | LNL- 8000 (Rev C² – 2.01.0) | |||
Port 1 | Port 2-9 | Port 1 | Port 2-9 | Port 1 | Port 2-9 | ||
LNL-3300 (EP2500) | S2 | Yes | Yes | No | Yes | Yes | Yes |
S3 | Yes | Yes | No | Yes | Yes | Yes | |
LNL-4420 (EP4502) | S2 | Yes | Yes | No | Yes | Yes | Yes |
S3 | Yes | Yes | No | Yes | Yes | Yes | |
LNL-X3300 (LP2500) | S2 | Yes | Yes | No | Yes | Yes | Yes |
S3 | No | Yes | No | Yes | Yes | Yes | |
LNL-X4420 (LP4502) | S2 | Yes | Yes | No | Yes | Yes | Yes |
S3 | Yes | Yes | No | Yes | Yes | Yes | |
- Rev C¹: Resistors R20 and R22 are NOT installed. Therefore, Port 1 will not function. Use new Rev C boards.
- Rev C²: Resistors R20 and R22 are installed. This board works with all the controllers (see Note below).
- Old LNL-8000 boards with U2 rev 1.01. LNL-X3300
Note: Not tested with all Controllers and downstream combinations.
Applies To
Additional Information
© 2024 Honeywell International Inc. All Rights Reserved.
Your Privacy Choices