Panels

How to run a debug on a Bosch (Radionics) panel Procedure Steps 1) Click Start, then select Run . 2) Type ACS.INI and click [OK]. 3) Add the following to the ACS.INI file under the [Service] section: [Radionics] DebugFile=1 4) Save t...

Symptom Certain drop-down lists inside the LNL-3300 and LNL-2220 Configuration Web Page are blank or unpopulated. Therefore, you are unable to make a selection from the drop-down list. Note: This does not apply to the LNL-1000, LNL-2000, an...

How to set up a Bosch DX4020 network interface module to communicate with Lenel OnGuard software Procedure Steps 1) You must first configure the DX4020 by setting DIP switches 1, 2, 3, and 4 to the OFF position (down), and DIP switches 5, 6,...

How to determine the firmware version of USRobotics 56K V.92 external modems Procedure Steps Obtaining the firmware version requires a HyperTerminal session on the server side. 1) Click the Start button, and then select All Programs > Acces...

Question Which TCP ports are used by the LNL-3300, X-3300 or LNL-2220, X-2220? Answer The LNL-2220 and LNL-3300 access panels use TCP ports as follows, when connected via Ethernet port. The LNL-3300, X-3300 or LNL-2220, X-2220 have an int...

How to troubleshoot communication problems with a Bosch 9412G Procedure Steps Typical Issues: 1.Cannot get panel online "follow steps 1-6 below 2.Panel cycles online and offline "follow steps 4-5 "if these don't work, go back ...

How to set the jumper for reader power on the LNL-2220 and Series 2 LNL-1320 Procedure Steps When setting Jumper J7 on the LNL-2220 or J2 on the LNL-1320 board, always use "PT" for any system with 12 VDC power supplies. Only use the "12V" sett...

How to configure automatic encryption for the LNL-500/1000/2000 controller Procedure Steps The controller must have a 256 KB chip in order to utilize encryption. 1) In System Administration, on the System Options > Controller Encryption tab,...

How to address devices connected to the LNL-8000 Procedure Steps Configuration of the device address is done in System Administration. 1) Configure the port for the device. This is the port number on the ISC that the LNL-8000 is connected to...

How to configure the LNL-2220 or LNL-3300 for direct connect Procedure Steps Configure the control panels as direct connect using the Configuration Web Page. Note: In order to connect to the web interface for the controllers, refer ...